MXF_MIL1553_RX_REC_CTRL_MSG_STATUS2_ADDRESS_ERRORĪ message was received with a bad RT address in the second RT-RT status word. MXF_MIL1553_RX_REC_CTRL_MSG_STATUS1_ADDRESS_ERRORĪ message was received with a bad RT address in the status word. Indicates that the message has a command (or two if MXF_MIL1553_RX_REC_CTRL_MSG_RT_RT is set). MXF_MIL1553_RX_REC_CTRL_MSG_DATA_LENGTH_ERRORĪ message was received with a bad number of data words. Indicates that data words were received and are included in the record. Indicates that the second status word of the RT-RT message was received and is included in the record. Indicates that the status word was received and is included in the record. MXF_MIL1553_RX_REC_CTRL_MSG_STATUS_BADSYNC_ERRORĪt least one of the data following a RT TX status has an invalid sync (normally an inverted sync). See KMXF_MIL1553_BM_MIN_RESPONSE_TIME attribute. The second RT of a RT-RT message responded too fast. MXF_MIL1553_RX_REC_CTRL_MSG_STATUS2_TOOFAST_ERROR Examples of unexpected data are: data received without a command or command with an error. MXF_MIL1553_RX_REC_CTRL_MSG_UNEXPECTED_ERROR MXF_MIL1553_RX_REC_CTRL_MSG_STATUS1_TOOFAST_ERROR MXF_MIL1553_RX_REC_CTRL_MSG_EXTRA_BIT_ERROR See mxfMsgAttributeUint64Set() function to enable the Checksum error detection. (Available on module with 1760 option only). MXF_MIL1553_RX_REC_CTRL_MSG_CHECKSUM_ERRORĪ message was received with a bad checksum word. MXF_MIL1553_RX_REC_CTRL_MSG_MANCHESTER_ERROR The message was received on bus B, otherwise, the message was received on bus A.Ī message was detected on the alternate bus before the message on the current bus was completed. Receive control bit - message mode: Bit option For acquisition, this bit field gives information about the receive record. A control of zero will transmit using the current channel setting. Field Documentationįor transmission, this is a bit field that enables the caller to override the current transmitter settings when transmitting the specified data records. In acquisition, it is used by mxfMIL1553RxAcqRead() function to read the received messages of BM, BC and RT channel. It is also used by mxfTxAperiodicWrite() function to transmit BC aperiodic messages. ![]() In transmission, it is used by mxfTxPeriodicUpdateMsgWrite() function to update data of messages for BC and RT channel. This MIL 1553 record structure is needed when sending (transmission) and receiving (acquisition).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |